Side Heat Shields; Brick Layout - England's Stove Works 30-NCP Manuel D'installation Et De Fonctionnement

3. Side Heat Shields

This accessory item comes
with the hardware (six (6)
mounting screws) necessary to
install it on the rear of the
stove. This is a two-piece heat
shield, but is installed one
piece at a time. There are pre-
punched holes on each side of
the Rear Heat Shield; while
holding each piece of the Side
Heat Shield in place, align the
pre-punched holes in the Side
Heat Shield with the existing
holes in the Rear Heat Shield,
and fasten with the screws
provided.
See Illustration 1 for
clearances with and without
side heat shields.
All Unmarked
Brick are Size "1"
1 – (Unmarked on diagram) – 9" x 4" x 1.25" brick (Qty. 25)
2 – 4" x 2" x 1.25" brick (Qty. 1)
Side
Heat
Shield
Illustration 3 – Side Heat Shield and Optional Blower Installation
Steel
Riser
3
4

BRICK LAYOUT

3 – 4" x 2 ½ " x 1.25" brick (Qty. 1)
4 – Metal plate (Ash Drawer Plate, Qty. 1)
12
Side
Heat
Shield
Rear Heat
Shield
Install AC-30 Optional
Blower on these (4) mounting
holes. See "Optional
Blower" Instructions.