WARNING
WARNING
ALWAYS use the electrical power (voltage and
frequency) specified on the model plate of the heater.
ALWAYS use only 14 AWG or better extension cord.
ALWAYS unplug the heater when not in use.
ALWAYS install the heater so that it is not directly
exposed to water spray, rain, dripping water, or wind.
WARNING
– Use heater in accordance with all local codes.
In the absence of local codes, refer to The
National Fuel Code, ANSI Z223.1.
–
convert to any other gas. Installation must
conform to local codes, or in their absence,
with the standard for the Storage and
WARNING
Figure 1
1. Remove all packing items applied to heater for
shipment. Keep plastic cover caps attached to
inlet connector and hose / regulator assembly
for storage.
2. Remove all items from carton
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE
CONNECTED TO A FUEL SOURCE
– Gas supply connections should be checked
– Locate LP cylinder at least 6 feet (10 ft. in
– Use only the regulator and hose assembly
Do not
3. Check all items for shipping damage. If the
3
The hose assembly shall be
WARNING
Handling of Liquefied Petroleum Gases ANSI/
NFPA 58 and the Natural Gas and Propane
Installation Code CSA B149.1.
by using a 50/50 soap and water solution.
Canada) from the heater, and do not direct
heater discharge towards the LP cylinder
unless it is at least 20 feet from the heater.
provided with this heater. Inspect the
regulator/hose assembly prior to each use of
the heater. If there is excessive abrasion or
wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list, prior
to using the heater.
Minimum and Maximum Inlet Pressure
MH-40
MH-60V MH-125V MH-150V
Min.
Max.
Bottle Pressure
X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X X
X
heater is damaged, promptly inform dealer
where you purchased the heater.
CAUTION
Propane Forced Air Heater User's Manual
.
5 PSI