emerio BG-111860.3 Mode D'emploi page 8

1. Insert the 4 pieces plastic feet into the handles. Make sure that the protruding part of all plastic feet are in
outside direction.
2. Install the handles onto the main body. Align the two screw holes on each handle and on each side of the
main body. Insert the ST2.9 screws into the holes. Tighten the screws to fix the handles and the main body
firmly.
Fill the main body with cold water. The maximum water capacity is 0.9L and the minimum water capacity is
0.4L. Do not add water that overflows the main body.
During use the water in the main body will evaporate and should be refilled. Otherwise, the product will get
too hot.
Note: Make sure you do not drip water on to the element.
Fig 2
Fig 3
Fig 5
Fig 6
- 7 -
Fig 4
Fig 6
Fig 7