Withings BPM Core Manuel D'utilisation page 42

RF Statement
EN
Medical Electrical Equipment needs special precautions
regarding EMC and needs to be installed and put into
service according to the EMC information provided in the
following.
Interference may occur in the vicinity of equipment
marked with the following symbol: | Portable and mobile
RF communication equipment (e.g. cell phones) can affect
Medical Electrical Equipment. | The use of accessories
and cables other than those specified may result in
increased emissions or decreased immunity | The device
uses RF energy only for its internal function. Therefore,
its RF emissions are very low and are not likely to cause
any interference in nearby electronic equipment | The
device is suitable for use in all establishments, including
domestic establishments and those directly connected
to the public low voltage power supply network that
supplies buildings used for domestic purposes | Portable
and mobile RF communications equipment should be used
no closer to any part of the device, including cables, than
the recommended separation distance calculated from the
equation applicable to the frequency of the transmitter
| The device is intended for use in an electromagnetic
environment in which radiated RF disturbances are
controlled. Any other accessories, transducers and cables
may result in increased emissions or decreased immunity
and EMC performance. | The device should not be used
adjacent to or stacked with other equipment and that
if adjacent or stacked use is necessary, which should be
observed to verify normal operation in the configuration
in which it will be used. Medical Electrical Equipment
needs special precautions regarding EMC and needs to
be installed and put into service according to the EMC
information provided in the following. Portable and mobile
RF communication equipment (e.g. cell phones) can affect
Medical Electrical Equipment. The use of accessories and
cables other than those specified may result in increased
emissions or decreased immunity of the unit.