Bosch PTK 3,6 LI Notice Originale page 33

 Use only original Bosch accessories. The precision parts of the pow-
er tool, such as the magazine, the striker and the shot duct, are
matched to Bosch staples. Other manufacturers use other steel quali-
ties and sizes.
Recommended Staple
Length
4 mm
6 mm
8 mm
10 mm
Tack Paper (see figures C1 –C2)
– Insert a suitable staple strip 9 .
– Click the lugs of the paper tacker 11 one by one into the side slots of
the power tool.
– Insert the stack of paper into the paper tacker 11 and position the tack-
er head over the paper surface to be tacked.
– Firmly push the power tool down until the tacker head 1 is pushed in a
few millimetres.
– Keep up the contact pressure and briefly press the trigger 5.
Once the staple has been completely driven in, release the trigger 5
and lift the tacker head 1 from the stack of paper.
Note: To load the magazine, you have to dismount the paper tacker from
the cordless tacker.
Tack Booklets (see figures D1 –D3)
– Before the first use, you must put the two halves of the booklet maker
12 together.
The booklet maker can no longer be dismounted.
– Insert a suitable staple strip 9 .
– Fold the top sheet (cover) of the stack of paper to be tacked in half, in
order to obtain an indication line for the staple position.
– Open the brackets 13 of the booklet maker 12 and place the paper
stack in the middle, with the cover facing upwards.
– Fold the brackets 13 downwards.
Align the paper stack in such a way that the indication line is visible
through the slots of the brackets.
Bosch Power Tools
Number of Sheets (80 g/m
Paper tacker
2 –10
2 –20
10 –40
20 –60
English | 33
2
paper)
Booklet maker
2 –10
2 –20
10 –30
20 –30
1 609 92A 096 | (29.5.13)