On/off switch
LED to display operating or charging status
(refer also to the chapter "Synexis chargers")
Push-button to mute the microphone
Microphone connection, 4-pin mini XLR
Set button
Line-In input to connect an audio source such as MP3 player,
mini stereo jack (3.5 mm)
Belt clip
Lid of the battery compartment
Charging contacts on the right and left hand side
Channel selector buttons
OLED display to indicate the channel, battery status, frequency and
channel lock function (on delivery with protective foil)
Mounting for strap
Gain switch, 3 stages Hi/Mid/Low
Battery compartment
Antenna
How to insert/replace the batteries
1.
Remove the belt clip
the lock-in position (see arrow in chapter "Controls and indicators"). Slide
down the lid
2.
Insert the supplied NiMH rechargeable batteries according to the polarity
marks. Before using the transmitter for the first time, the rechargeable
batteries inside must be charged e.g. with the Synexis C8 or C10 charger. As
an alternative you can use two 1.5 V AA alkaline batteries.
3.
Close the battery compartment
4.
If the transmitter is not being used for weeks or months, please remove the
batteries. Batteries can leak when not being used for a long time and damage
the device.
How to operate the transmitter
1.
Connect a microphone to the 4-pin mini XLR socket
connector will correctly lock in place.
Note
In order to avoid popping noise in the Synexis RP8 receiver, you should
connect the microphone when Synexis TP8 receiver is turned off.
2.
Turn on the beltpack transmitter with the on/off switch
illuminate blue. The selected channel and the battery status are displayed
Make sure that transmitter and receiver operate on the same channel.
3.
If you wish to select a different channel, Use one of the two channel selector
buttons
to select the requested channel. If you release the channel selector
by levering out the clip with pressure to the rear from
to open the battery compartment
by sliding the lid
.
to the top.
. Make sure the
. The LED
6 | 7
will
.