Standard Equipment - Stanley FatMax FME700 Manuel D'instructions

NOTE: Capacity shown on chart assumes no wheel wear and optimum fence position.
MAXIMUM CUTTING CAPACITY
Workpiece Shape:
90° Cutting Angle
45° Cutting Angle
1 14 inch (355mm) Metal Cutting Abrasive Wheel

STANDARD EQUIPMENT

1 Wheel Wrench
1 Instruction manual
Fold down unit to position where you can carry the saw. Hook
TO CARRY (FIG. 1a)
lock chain (A) to chain hook (Q).
To unlock tool and raise head, depress motor arm slightly and
UNLOCKING (FIG. 1a)
unhook lock chain (A) from chain hook (Q). Motor arm will
then pivot upward.
To best deflect sparks away from surrounding persons and materials, loosen the screw (B),
SPARK DEFLECTOR ADJUSTMENT (FIG. 1)
adjust the spark deflector (C) and then retighten screw. Do not allow cordset to come into
contact with deflector or sparks as damage to cordset may occur.
Depth stop is set at the factory for a new 14 inch (355mm) wheel to prevent wheel from
DEPTH STOP (FIG. 1)
cutting into the supporting surface. To allow more depth of cut, use the flat wrench provided
(G) to loosen the depth stop bolt (M) and lower bolt to desired height and then turn jam nut
(M) clockwise until seated firmly on the casting. Securely tighten the depth stop bolt before use.
When changing to a new wheel, readjust depth stop to original position to
prevent cutting into supporting surface. CAUTION:
To start the tool, depress the trigger switch (N). To turn the tool off, release the trigger
TRIGGER SWITCH (FIG. 1)
switch. Keep hands and material from wheel until it has coasted to a stop.
To prevent unauthorized use of tool, install a standard padlock (not included) into the
padlock hole (O) located in the trigger.
A X B
A = 4-7/8 in A = 4-1/2 in
(125mm) (115mm)
A = 4-1/2 in A = 3-13/16 in 4 1/2 in x 3 13/16 in
(115mm) (98mm)
4 1/2 in x 5 1/8 in
(115mm x 130mm) (115mm x 137mm)
4 in x 7-5/8 in
(102mm x 188mm)
3 in x 7-3/8 in
(76mm x 229mm)
4 1/8 in x 3 3/4 in
( 105mm x 95mm)
6
A = 4 1/2 in x 5 3/8 in
A = 3-13/16 in
3-3/4 in
(95mm)
Fig. 1a
Q
A