Hoover ALYX Mode D'emploi page 4

ENGLISH
Carpet/floor nozzle (9)
A) Carpet position - brushes in
B) Hard floor position -
brushes out
Cleaning tools (10)
A multi cleaning tool is supplied
with your product. This tool is
stored on board the cleaner as
shown.
The multi tool brushes can be
deployed to create a dusting
brush.
EMPTYING AND CLEANING DUST
CONTAINER AND FILTER
Important: Switch
cleaner off and remove plug
from electricity supply
before emptying dust
container or removing any
filters
DO NOT use the cleaner without
the dust container or filters in
place.
Emptying the dust container (11)
For optimum performance HOOVER
recommends that you empty the
dust container after each use.
To empty the dust container:
• Push the release button on
the dust container top (11A).
• Lift out the dust container
using the carry handle (11B).
• Position the dust container
over a bin before opening
• Press the latch on the handle
to open the dust container door
and dispose of the dust (11C).
• Close dust container door and
refit the container in its
original position in the cleaner.
10
Accessing the Hepa Pre motor
filter (12)
In order to access the Hepa Pre
motor filter, follow these steps.
• Remove the dust container from
the cleaner.
• While holding the dust container
handle, grip the top cover.
• Rotate the top cover
anticlockwise to the unlocked
position and remove from the
dust container (12A, B).
Maintaining the Hepa Pre Motor
filter (13)
Hoover recommends that you wash
the filter after five container
empties.
• Remove the Hepa pre-motor
filter by rotating it clockwise
• Tap the Hepa pre-motor filter
over a bin.
• Rinse under hand warm water, if
necessary (13C).
• Leave to dry for 24 hours or
until completely dry before
refitting.
• Refit filter by aligning the filter
locking features to the
locations in the cover and
rotating the filter anti-clockwise
until locked.
IMPORTANT: NEVER USE THE
CLEANER WITHOUT PRE-MOTOR
FILTER FITTED
Changing the exhaust filter (14)
Hoover recommends that you
replace the exhaust filter every 3
months.
• Press the exhaust filter grid
latch to gain access to the
exhaust filter.
• Remove the filter.
• Fit new filter and refit the
cover in its original position.