Technical Data; Battery Exchange - Würth 0715 53 200 Traduction Des Instructions De Service D'origine

Technical data

Item
Contamination level
Indicator
Dimensions
Batteries
Degree of protection
Measuring range
Operation ( g. I)
Self-test
After pressing the button [1] brie y, the device
performs a self-test and the "batt" LED [2] lights
up for a short time.
Test
Open the cap of the brake liquid container.
Remove the plug [3] of the tester.
Dip the test probe into the brake liquid up to the
plastic edge.
To evaluate the quality, press the button [1] for
at least two seconds and simultaneously read the
result from the LEDs [2].
Warning:
The device is only designed for the
purposes described in these operating
instructions. If the device is used for other
purposes, this can result in accidents or
in destruction of the device. The device
must not be changed in its design.
Warning:
The device must not be used for meas-
urements in electric circuits.
Note
Pay attention to the information of the
vehicle manufacturer and the brake
liquid manufacturer on changing the
brake liquid.
Note
The measurement is an additional
information. It does not replace the data
given by the manufacturer of the vehicle
(e.g. change intervals).
8
0715 53 200
2
Optical / 5 LEDs
L = 151 mm / Ø = 23.5 mm
1 1.5 V type AAA Micro
IP 40
DOT4
To avoid contamination of the brake liquid with
moisture, keep the e pansion vessel open for a
short time only.
Do not measure too often.
Always rinse the test probes with water and dry.
Re-install the plug [3].
Note
Ensure there no residues of the brake
liquid remain on the test probes or on
the device.

Battery exchange

Open the battery lid [4] carefully with a screw
driver.
Replace the discharged battery with a Würth
spare battery (Item 0827 111).
Observe proper polarity when inserting
the battery!
Indication ( g. I)
Green:
Water content in the brake uid is OK. There is no
water in the brake uid.
Green /yellow:
Less than 1 water in the brake uid
Green /yellow / yellow:
Appro . 2 water in the brake uid
Green / yellow / yellow / red:
Appro . 3 water in the brake uid,
Change the brake uid!
Green / yellow / yellow / red / red:
at least 3 water in the brake uid,
Brake liquid must be changed immediately!
Safety risk!
Note
If brake liquid comes in contact with
your skin or clothes, rinse thoroughly
with water. Brake liquid must not be
e posed to the atmosphere since it is
highly hygroscopic!