User Maintenance Instructions - BaByliss PRO FXX3S Directives D'utilisation

• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
SUPPLIER'S DECLARATION OF CONFORMITY
Brand: BaBylissPRO
®
Model No.: FXX3S
Description: Shaver
Responsible Party: Conair Corporation,
1 Cummings Point Road
Stamford, CT 06902
(203) 351-9000
Standards: FCC Part 15 Subpart B, ANSI C63.4-2014
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause
undesirable operation.
DATE OF ISSUE: 01/27/2021
USER MAINTENANCE
INSTRUCTIONS
TAKING CARE OF YOUR SHAVER
Always switch the shaver off before removing the shaving foil unit!
Ensure that no water gets inside the shaver to avoid risk of electric shock when
it is back in operation.
Never press on the cutting blades or the shaving foil and do not touch them
with hard objects, as this can cause irreparable damage to the shaver or parts.
Be careful when dealing with the blades, as they are very sharp and pose risk
of injury! When cleaning, do not apply any detergents or scouring agents and
FXX3S IB-17245.indd 7-8 FXX3S IB-17245.indd 7-8
do not use any abrasive or sharp objects. They can cause irreparable damage
to the shaver.
NOTE: When cleaning your shaver, make sure the unit is turned off.
CAUTION!
• DO NOT run shaver or cutters under water. Use only the small brush (included)
to clean.
• To clean the external surfaces of the shaver, use a damp cloth. Do not use
strong detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
• The shaver should not be used until it has completely dried.
• For connection to power supply not in the U.S.A., use an attachment plug
adapter of the proper configuration for power outlet. The included adapter
automatically adjusts to the input voltage. DO NOT USE A VOLTAGE
CONVERTER.
TO REPLACE FOIL HEAD ASSEMBLY
1. Remove the foil head assembly by pressing the release button located on the
side of the shaver. Hold the foil head assembly on both sides and lightly pull
it away from shaver unit.
2. Take the replacement foil head assembly (FXX3RF) out of package. Align
the replacement foil head assembly over the cutters. Carefully move the
replacement foil head assembly down towards the shaver unit until it firmly
snaps into place. BE CAREFUL NOT TO DAMAGE THE FOILS OR CUTTERS
WHILE INSTALLING.
TO REPLACE CUTTERS
NOTE: Always replace the cutters and foil head assembly at the same time.
1. To remove cutters, place your fingers on each side and gently pull up and
away from drive shaft.
2. To replace cutters, remove the new cutters (FXX3RF) from the packaging. Align
cutter with the drive shaft and lightly push down until it snaps into place.
3. Replace the foil head assembly, turn shaver on to ensure it is working
properly.
2021/3/23 9:50 AM 2021/3/23 9:50 AM