Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
running up and all 4 charging lights will remain alight. Charging is complete
after 3 hours.
3. This product has 4 LED lights that indicate battery capacity when charging
or discharging.
• When all 4 lights are illuminated blue, it indicates 100% battery capacity.
• When 3 lights are illuminated blue, it indicates 75% battery capacity.
• When 2 lights are illuminated blue, it indicates 50% battery capacity.
• When 1 light is illuminated blue, it indicates 25% battery capacity.
4. When the product is about to run out of battery, the last charging indicator
light will flash to indicate that there is approximately 10 minutes use of
battery capacity remaining.
5. The ada pter may become warm while charging. This is normal.
6. Preserving the battery: In order to maintain the optimum capacity of
the rechargeable battery, the shaver should be recharged for 3 hours
approximately every 6 months.
7. Make sure the switch is in the OFF (O) position when the shaver is not
operating.
WARNING:
If all 4 charging lights light suddenly start to flash
rapidly, the appliance is faulty. If this happens, please stop charging and remove
the adapter from the outlet and contact our Customer Care Center for further
advice (see the Warranty section of this information booklet).
FOR DIRECT PLUG-IN OPERATION
Make sure shaver is off. Connect charging jack into the receptacle at the bottom
of shaver and plug the adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch to the ON (I) position. To stop operation, set to
the OFF (O) position.
VERY IMPORTANT: Cutters must be cleaned and oiled on a regular basis
for proper functioning. Failure to regularly clean and oil the cutters will
void the warranty.
FXX3S IB-17245.indd 5-6
FXX3S IB-17245.indd 5-6
BASIC INSTRUCTIONS FOR USE
1. Men whose skin is sensitive or easily irritated by shaving, or who suffer from
a skin allergy, should test one section on the leg or arm before using the
shaver on the face.
2. Remove the protective cover and turn on the unit to start shaving. Hold the
shaver at a right angle to the area that you want to shave and run the double
shaving foil carefully along your skin. Tip: In general, we recommend that
you shave against the direction of hair growth, as this is the best way to
trim the hair. Pull your skin tight with your fingers in inaccessible areas to
achieve optimum results.
3. Switch the shaver off each time after shaving and clean it.
4. Do not push the shaver on the skin too hard, as it could cause irritation, make
the shaver warm and prevent a perfect shave.
5. Please note that it takes 2 to 4 weeks for your skin to adapt to a shaver, so
please do not change shaving instruments in this period of time.
6. If hair is longer than 1/32", begin by cutting the hair down first with a
trimmer, then use shaver for a smooth close shave.
FEDERAL COMMUNICATIONS COMMISSION NOTICE
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
2021/3/23 9:50 AM
2021/3/23 9:50 AM
Publicité
Table des Matières
