coltene/whaledent ParaPost FIBER LUX Mode D'emploi page 5

ParaPost ® F L
IBER UX
Drills: Prior to each use, remove debris ultrasonically or by
hand scrubbing with a brush; thoroughly rinse and dry. Place
drills, with a sterilization indicator, into an autoclave bag and
seal. Steam sterilize at 132°C for 12 minutes. Sterilizing bags
should not touch the walls of the autoclave. Once the
sterilization monitor indicates that sterilization was achieved,
place autoclave bag, with the drills inside, in storage until ready
for use. To decontaminate, soak in a 70% isopropyl alcohol
solution for 10 minutes.
Universal Hand Driver: Prior to each use, remove debris
ultrasonically or by hand scrubbing with a brush. Sterilize by
following instructions for drills above.
Warning Notice: DO NOT BEND POSTS!
Post Removal Technique
1. Take a radiograph of the tooth that requires post
removal.
2. Carefully estimate length and diameter of ParaPost
Fiber Lux post to be removed.
3. Remove any restorative or core material which may be
in the way to gain direct straight-line access to the post.
4. Wear safety mask when removing post from tooth.
Indent the center of the post using a # 1/2 roundbur at
high speed.
™
5. Carefully drill an initial channel into the center of the
ParaPost Fiber Lux post using a Kodex twist drill (cat. #
K95 or K97) at slow speed.
6. Carefully drill to full depth through the center of the post
using an end cutting Tenax Starter Drill (cat # Te-DC-1,
Ø .036"/0.90 mm) or Tenax Drill (cat # Te-A-11,
Ø. 043"/1.1 mm). Check radiographically at stages.
7. Gradually work up to original diameter using standard
ParaPost drills.
8. Re-treat endodontically, if necessary.
9. Re-restore with new post/core and restoration.
Always verify steps via radiograph.
* References and/or literature available upon request.
**Sporox II is a registered trademark of Reckitt &
Coleman, Inc.
Instructions For Use
5