Grohe Blue Pure Mode D'emploi page 6

Warning
Risk of damage:
Always disconnect the power supply before performing
maintenance work on the system. The plug-in connectors
can then be disconnected, see fold-out page II, Fig. [8].
Inspect and clean all components and replace if necessary.
I. Cartridge, see fold-out page II, Fig [11].
Assemble in reverse order. When installing the cartridge,
ensure that the seals are correctly seated. Replace screw
coupling and tighten.
II. Headpart, see fold-out page II, Fig. [12].
Assemble in reverse order. Note the installation position of the
stop.
III. Flow control (64 374), see fold-out page I.
Assemble in reverse order.
Fault Cause
• Water supply interrupted
Water not flowing
• Water supply interrupted
Filtered water not
flowing
• No connection between faucet and
No filtered water, E3
cooler/carbonator
in the display
• Cable or connector faulty
• Faucet and control unit not synchronized
No filtered water,
®
Blue handle flashes
red, E4 in the display
• Values range does not concur
No filtered water,
®
Blue handle flashes
red, E6 in the display
• Filter capacity exceeded
®
Blue handle flashes
orange, E7, E8 in the
display
• Control not recognised
Indicator lamps
do not flash/flash
continuously
• No connection between faucet
Display in handle
and control unit
does not illuminate
or illuminates
continuously
3
English
Service
Note the Fault / Cause / Remedy table for information on
eliminating problems.
If EE flashes or the problem cannot be rectified, interrupt the
power supply and consult a specialist installer or contact the
GROHE Service Hotline via email under TechnicalSupport-
HQ@grohe.com.
Replacement parts
See fold-out page I (* = special accessories).
Care
Instructions for care of this faucet will be found in the Limited
Warranty supplement.
Environment and recycling
Used filter cartridges can be disposed of hazard-free in
domestic waste.
Remedy
- Open shut-off valves
- Establish water supply to faucet
- Connect plug-in connector
- Contact GROHE Service
- Synchronise with one another, see section
Installation
- Synchronise with one another, see section
Installation
- Change filter cartridge immediately
- With mains plug connected, disconnect plug-in
connector, wait 30 seconds and reconnect
- Synchronise with one another, see section
Installation