Before Using; Using Your Appliance - Krups FDK2 Mode D'emploi

A Waffle plates fixed with non-stick (2)
B Thermo-insulating handle
C Locking clip
The explanatory drawings are on page 58
Put the appliance on a firm surface.

Before using:

„ Fully unwind the lead.
„ Open the appliance.
„ Remove all packaging, labels or accessories from the inside and outside of the appliance.
„ Coat the plates lightly with cooking oil or spray with a non-stick aerosol.
„ Wipe with a soft cloth.

Using your appliance

„ Close the appliance.
„ Check that the switch is set at 0.
„ Connect the lead to the mains. Set the switch (f) to on (position 1). The red light (d) comes
on (1).
„ Leave the appliance to pre-heat: the green light (e) comes on when the cooking
temperature has been reached (2).
„ Open the appliance (3). Using a ladle, pour the waffle batter onto the lower plate of the
appliance.
„ Pour the batter taking care to cover each square and not to let it overflow.
„ Close the appliance.
„ Leave to cook for the time stated in the recipe.
„ While the waffles are cooking it is normal for the green light to switch on and off.
„ At the end of cooking, switch the appliance off by pressing 0. Then disconnect the plug.
„ Leave to cool for 2 hours.
„ Always disconnect the appliance before cleaning, and leave to cool completely.
„ Do not immerse the appliance.
To clean the exterior,
wipe with a damp cloth and dry.
To clean the interior,
wipe the plates with a damp cloth, some dishwashing soap may be used. Then wipe with a
wet sponge and dry carefully.
13
DESCRIPTION
D Appliance switched on light
E Setting light
F Switch
INSTRUCTIONS
CLEANING