Faber Dama Isola Mode D'emploi page 10

DUE TO THE SIZE AND WEIGHT OF THIS RANGEHOOD, THREE PEOPLE ARE REQUIRED TO INSTALL THE CANOPY.
Two people must hold the canopy in place while the third person installs the screws that attach the canopy to the chimney.
The manufacturer assumes no responsibility for injury or damage caused by improper installations.
4. From below, attach the CANOPY SECTION (A in FIGURE
12) to the assembled chimney support using the four bolts
provided (F in FIGURE 14).
MAKE THE INTERNAL ELECTRICAL CONNECTIONS
5. Connect the CONTROL CABLES together as indicated in
A in FIGURE 15. Connect the LIGHT CABLES together as
indicated in B in FIGURE 15. Insert the connected CONTROL
CABLES (A in FIGURE 15) into the black plastic CONNECTOR
BOX (C in FIGURE 15) by connecting the two black plastic
pieces using the four screws provided. Using the two longer
screws provided, attach the assembled CONNECTOR BOX to
the METAL FLANGE (D in FIGURE 15).
A
D
!
FIGURE 14
A
B
C
B
FIGURE 15
WARNING
For ductless installations, install the CHARCOAL FILTER (F in
FIGURE 12) behind the center grease filter opening by inserting
and locking into place. See FIGURE 16
6. Install the grease filters (FIGURE 17).
7. Turn the power supply on. Turn on blower and lights. If the
rangehood does not operate, check that the circuit breaker is
not tripped or the house fuse blown. If the unit still does not
operate, disconnect the power supply and check that the wiring
connections have been made properly.
FIGURE 16
FIGURE 17