Malfunctions; After-Sales Service - Fox F12-961A Manuel D'instructions

PROBLEM
The drill press does not start
The tools wear rapidly
The engine does not work properly
The axle goes up and down with
difficulty:
All tools and accessories are made and checked by using the safest and most modern productive methods.
However, if despite these attentions a tool gets damaged, it must be repaired by a Femi authorised after sales
centre.
You can send a request to the e-mail address info@fox-machines.com.
EN

MALFUNCTIONS

POSSIBLE CAUSE
- The electric current is missing in the socket to which the supply
cable is connected.
- The supply cable is faulty
- The engine is damaged
- The cover of pulleys' box is not closed
- The tool is not correctly sharpened
- The tool is not suitable for the material to be cut, or the lubricant
oil is missing during metal cutting,
- Too high advance
The engine may be damaged: get the machine checked by an
electrician
Clean and grease the axle of the spindle under the pulley.

AFTER-SALES SERVICE

20