General Safety Instructions - Fox F12-961A Manuel D'instructions

1. Keep the work surface clean. If the work area or surface is busy the probability of injuries is higher.
2. Do not use the machine in dangerous environment conditions. In order to prevent electric shock, do not
expose the machine to rain and do not use it in a damp area. Keep the work area illuminated. Do not use
the machine near gas or inflammable substances.
3. Connect the dust collection device. If the machine is provided with a dust collection device, make sure that
this system is connected and correctly used.
4. Keep unknown persons and children away from the machine. All unknown persons and children must keep a
safe distance from the work area.
5. Protect yourself from electric shock. Avoid any contact with earthing surfaces.
6. Handle the power supply cable with care. Do not pull the electric cable to disconnect it from the plug. Keep
the electric cable away from heat, oil and sharp edges.
7. Use extension cables designed for outdoor use. When using the machine outdoors, use only extension cables
suitable for outdoor use, having specific indications.
8. Be vigilant. Check carefully what you are doing, have good sense. Do not use the machine if you are tired.
9. Do not use the machine if you are have taken medicines, alcohol, drugs.
10. Avoid accidental starts. Be sure that the switch is on the OFF position before inserting the plug into the
socket.
11. Wear appropriate clothing. Do not wear loose-sleeved garments or pieces of jewllery which may get caught
in the moving parts. For outdoor use we recommend non-slip shoes. Use headgear to cover hair if necessary.
12. Use always personal protection devices: wear protective goggles and masks in case dust or sawdust is
produced. Wear ear muffs or plugs in noisy areas. Wear gloves when handling parts with sharp edges.
13. Do not be off balance over the machine. Always keep stand firmly.
14. Ask for advices to expert and qualified people if you are not familiar with using such a machine.
15. Remove the tools you do not use from the workbench. If you do not use the tools, you must arrange them in a
dry area which is locked and away from the reach of children.
16. Do not force the machine. You can obtain better and safer results if you use the machine at the cutting
pressure for which it has been designed.
17. Use the suitable tool. Do not use a small tool for an intensive job. Fox example, do not use a circular saw to
cut branches or stumps.
18. Block the piece. If possible, use C-clamps or a holder to fix the piece. It is safer than using only your hands.
19. Keep the tools in perfect conditions. Keep the tools sharp and clean to obtain better and safer results. Follow
the instructions to grease and change the accessories. Check regularly the electric cable and change it if it is
damaged. Keep the handles and the handgrips dry, clean, unoiled and ungreased.
20. Disconnect the tool from electricity if you do not use it, before maintenance and change of the accessories or
tools such as blades, drills, mills, etc.
21. Remove locking and adjustment wrenches from the workbench. Get used to check if the locking and
adjustment wrenches have been removed before starting it.
22. Check the parts of the tool to verify that there are not any damages. Before using the machine, check if the
safety devices or any other parts are damaged in order to be sure that it works properly and that it can
accomplish the tasks for which it has been designed. Check that the moving parts are aligned, do not stop
and are not broken. Check the assembly and any other condition that can influence the functioning of the
machine. Any part or protection damaged must be repaired or changed from an authorized after sales centre.
Do not use the machine if the switch does not work properly.
23. Use the machine, the tools and accessories in the way and for the purposes mentioned i this manual.
Different uses and parts can cause possible risks for the operator.
24. Get the machine repaired by a qualified person. This electric tool is in compliance with local safety
regulations. The machine must be repaired only by qualified people who use original spareparts, otherwise
risks may arise for the operator.
EN

GENERAL SAFETY INSTRUCTIONS

13