Brecknell CS-200M Manuel D'installation page 5

Seat and Footrest Installation
Once the transport handle is attached the next step is to install the molded seat to the scale support
frame.
1. Remove the four screws from the movable scale support frame platform and set aside.
Figure 9. Removable Screws on The Movable Scale Support Frame
2. Set the chair onto the scale support frame platform but do not fasten the screws as the footrest
assembly will also have to be put into place prior to tightening all screws.
3. Remove screws from the chair frame (shown in Figure 10) and set aside.
4. Tilt the chair upwards as shown in Figure 10. This will allow the installer to get the footrest assembly in
place prior to securing the chair to the platform
Figure 10. Tilt the Chair Upward Before Installing the Footrest Assembly
5. Slide the footrest assembly onto the chair scale base as shown in Figure 10.
Note that the footrest assembly for the footrest is hanging on the metal chair channel and lined up
with the screw holes on the channel of the chair scale frame as shown in Figure 11.
Four screws on scale support
Frame – only one screw shown
5