Klarfit 10032653 Mode D'emploi page 17

• Assemble the iron bars (D1 + D2). One iron bar (D1) has a hole and the
other iron bar (D2) has a clamp.
• Assemble the two iron bars (D1 + D2) and make sure that the clamp is in
the correct position and cannot be easily pulled out.
• Put the iron bar (D) together with the iron bar (B) on which the curved bar
(C) is already attached.
• Use a long screw (9) and a PVC washer (10) to fix the iron bar (B) and use
the wrench (10) to tighten.
• NOTE: The big hole is for inserting the rod and the small hole is for
fixing the screw.
Step 8
Step 9
EN
17