Installation; Unit Installation; Electrical Connection; Guarantee - AEG WKL 503 Notice D'utilisation Et De Montage

for the user and the professional installer
On installation of the heater in rooms with a bath and/or shower, the protection area to VDE 0100 part

701 as specified on the unit rating plate must be observed.
The unit must be mounted such that the switch and control units are out of reach of a person in the

bath or shower.
The mains connection cable may only be replaced with original spare parts by experts.

2.3

Installation

2.3.1 Installation of wall bracket
The wall bracket should be used as a template for fixing the appliance to the wall. It also helps to keep
the necessary ground clearance. To attach the unit proceed as follows:
Place the wall bracket (5) holding the centre point horizontally on the ground and mark the holes a and
 I
d on the assembly wall;
Raise the wall bracket so that the holes b in the wall bracket coincide with the marks just made on
II

the assembly wall;
Mark holes c and d on the wall bracket on the assembly wall;

At all four markings drill holes and attach the wall bracket to the wall using suitable fixing materials

(wall plugs and screws) dependig on the type of wall. The vertical slots allow adjustment for an offset in
the fixing holes.
2.3.2

Unit installation

The convector is mounted by attaching the slots on the rear simultaneously to the four tabs of the wall
bracket pressing down to lock. The closing bolt (6) of the wall bracket is then turned clockwise to the
stop, locking the fixing. To remove the convector, unscrew the locking bolt and lift the unit slightly,
pulling it forwards and out of the bracket.
2.4

Electrical connection

The required electrical connection is AC 230V.
For fixed connection, an earth socket or junction box should be installed at a distance of
at least 100 mm to the side of the heater.
2.5 Handover
Explain to the user how the unit functions. Draw his attention in particular to the safety instructions.
Give the user these operating and usage instructions.
3.

Guarantee

For guarantees please refer to the respective terms and conditions of supply for your country.
The installation, electrical connection and first operation of this appliance should be carried out by a
qualified installer.
The company does not accept liability for failure of any goods supplied which accor-dance with the
manufacturer's instructions.
3.1

Environment and recycling

Recycling of obselete appliances
Appliances with this label must not be disposed off with the general waste. They must be coll-
ected separately and disposed off according to local regulations.
B
C
15