MSI 970 GAMING Mode D'emploi page 22

CPU & Cooler Installation
When you are installing the CPU, make sure the CPU has a cooler attached on the
top to prevent overheating. Meanwhile, do not forget to apply some thermal paste on
CPU before installing the heat sink/cooler fan for better heat dispersion.
Follow the steps below to install the CPU & cooler correctly. Wrong installation will
cause the damage of your CPU & motherboard.
1. Pull the lever sideways away from the socket. Make sure to raise the lever up to a
90-degree angle.
2. Look for the gold arrow of the CPU. The gold arrow should point as shown in the
picture. The CPU can only fit in the correct orientation.
3. If the CPU is correctly installed, the pins should be completely embedded into
the socket and can not be seen. Please note that any violation of the correct
installation procedures may cause permanent damages to your motherboard.
4. Press the CPU down firmly into the socket and close the lever. As the CPU is
likely to move while the lever is being closed, always close the lever with your
fingers pressing tightly on top of the CPU to make sure the CPU is properly and
completely embedded into the socket.
En-8