Maintenance & Troubleshooting - Bradley S19-671H Installation

Installation
Maintenance
WARNING: Water preservatives protect potable water from bacteria, fungi and algae growth for up
to 120 days. If a water preservative is not used with this eyewash, it is recommended that the tank
be cleaned weekly or as often as needed. Infection, loss of vision or other serious injury may result
from misuse of this eyewash. DO NOT use expired, cloudy, colored or contaminated solution. DO
NOT open preservative bottle if safety seal is broken. DO NOT save unused solution.
Step 1: Inspect eyewash unit
1. Visually inspect the pressure gauge weekly to ensure the unit is maintaining the proper pressure. If the unit is not
working properly, remove it from the hazard area immediately and refer to the troubleshooting instructions. For further
assistance, contact the Bradley Corporation.
Step 2: Clean eyewash unit
When using potable water only:
1. Empty the tank any time from once per week to once per month, depending on the quality of your water supply. The
manufacturer is not responsible for variations in the water supply.
2. Clean the inside of the tank using warm water and mild soap. Rinse the tank thoroughly with warm water.
3. Refill the eyewash tank following the procedure outlined in Step 3 found on page 3.
When using potable water and water preservative (recommended):
1. Empty the tank at least once every 120 days.
2. Clean the inside of the tank using warm water and mild soap. Rinse the tank thoroughly with warm water.
3. Refill the eyewash tank with potable water and the contents of an 8-ounce bottle of water preservative (refer to the
procedure outlined in Step 3 found on page 3).
• To order potable water preservative, contact your Bradley representative or local distributor and ask for part number
S19-865.
Troubleshooting
1. If pressure relief valve relieves prior to the required pressure, do the following (when in the unpressurized condition):
• Tighten the valve completely into the cap by turning the gray hex head portion of the pressure relief valve
clockwise. Do not use a wrench.
• Pull up on the relief valve ring and ensure that the ring is not preventing the valve from closing completely. Push
on the center pin of the relief valve to ensure that it is completely closed. Repressurize tank to required pressure.
This may have to be done several times to get the valve to seat completely.
2. If the pressurized tank loses pressure over time, check the connections with diluted liquid dish soap or children's
bubbles to identify the leak location. Tighten the connection slightly and test again.
Bradley Corporation • 215-321A Rev. U; ECM 08-539
S19-671H, S19-671HR
6/9/09 5