Making Recordings Manually; Making Recordings Continuously; Making Recordings During Motion Detection - Eminent EM6104 Mode D'emploi

7.2 Making recordings manually

1. Make sure the surveillance recorder is completely started and you can see the
surveillance recorder's image on screen.
2. Click the 'Rec' button at the lower right part of the screen.
3. You need to login using an admin account. Fill out the password you have set
during the wizard and click 'Login' or do not fill out a password if you have not
used the wizard or if you do not have set a password and click 'Login'.
4. The surveillance recorder will start recording the camera's image.
5. If you want to stop the recording, you need to click the 'Stop record' button at the
lower right part of the screen.

7.3 Making recordings continuously

1. Make sure the surveillance recorder is completely started and you can see the
surveillance recorder's image on screen.
2. Click 'Start'.
3. You need to login using an admin account. Fill out the password you have set
during the wizard and click 'Login' or do not fill out a password if you have not
used the wizard or if you do not have set a password and click 'Login'.
4. Click 'Basic'.
5. Click 'Record'.
6. Make sure the channel(s) you want to record from are marked. (Place a mark at
'Enable). Also, the 'Mode' needs to be set to 'Always'.
7. Click 'Apply'.
8. Click 'OK' at the 'Successfully saved' screen.
9. Click 'Exit' until you are at the main menu.

7.4 Making recordings during motion detection

1. Make sure the surveillance recorder is completely started and you see the
surveillance recorder's image on screen.
2. Click 'Start'.
3. You need to login using an admin account. Fill out the password you have set
during the wizard and click 'Login' or do not fill out a password if you have not
used the wizard or if you do not have set a password and click 'Login'.
4. Click 'Advance'.
5. Make sure the channel(s) (CH) you want to record from using motion detection are
marked (Place a mark at 'Enable).
6. Click the field below 'Sensitivity'.
7. Select the sensitivity of the motion detection for the selected channel. You can
make a selection between '1' till '8'. '1' is the most sensitive, '8' is the least
sensitive.
8. Click the 'Setting' field below 'Area'.
9. The image of the selected channel (CH) will be shown. By default, the entire
screen is selected as motion detection area (green colour). By pressing the left
15 |
ENGLISH