Automatic Serach (Cable); Manual Search (Cable); Picture - Megasat Royal Line II 19 Mode D'emploi

7. The Main Menu

7.1.12 Automatic Serach (Cable)

Before starting a station search, make sure
you are on the correct input source. To do
this, press the INPUT button on the remo-
te control and select the item „Cable".
In the search mode, choose between „Full" or „Network Scan". When „Full" the default
search is used, with „Network Scan" you can u.a. set the frequency or network ID.
Then press OK and select the country you
are in (eg Germany).
Subsequently, the automatic transmitter
starts.

7.1.13 Manual Search (Cable)

With the manual DVB-C search you can se-
arch each frequency (channel) individually.
Select the desired frequency with the
t u
buttons. Press the OK button to search to
start the search.
18
ENGLISH
7. The Main Menu

7.2 Picture

In this menu you can set up basic settings for
the TV picture. Use default settings or set your
own values.
Image Mode
Select a preset image setting
Contrast
Adjust the contrast value
Brightness
Adjust the Brightness value
Color
Adjust the Color value
Color tone
Adjust the Color tone value
Sharpness
Adjust the Sharpness value
Color temp.
Adjust the Color temperature value
Image format
Set the appropriate picture format.
Noise reduction
Adjust the Noise reduction valuen
Dynamic CR
Set the dynamic contrast ratio on or off.
Note:
The settings such as contrast, brightness, etc. can be edited only if you are in the
picture mode „Personal".
ENGLISH
19