Edit Satellite; Signal Informations - Megasat Royal Line II 19 Mode D'emploi

7. The Main Menu

7.1.5 Edit Satellite

In this menu, you can make fundamental
changes to your satellite system, edit or
add transponders and satellites.
Add / Delete Satellite
Delete (RED button)
Deletes the selected satellite. This process
is irrevocable.
Add (YELLOW button)
Add a new satellite. Enter the name and
orbit position of the new satellite.
Edit Satellite
Select a satellite and press the OK button to
make further settings.
You can make the following settings here:
LNB Type
Change the LNB type here
DiSEqC 1.0
Choose between None, LNB 1 to LNB 4
DiSEqC 1.1
Choose between None, LNB 1 to LNB 16
22 KHz
Set the 22 KHz setting to On or Off.
Transponder
Opens the transponder list. Use the RED button to delete the selected transponder. Use
the YELLOW button to add a transponder.
14
ENGLISH
7. The Main Menu
Note:
As new Channels are available, but these are not located in your TV list, proceed as
follows:
1. Find out the frequency of the new channel (e. g. on „www.satindex.de").
2. Go to the main menu Channel -> Edit Satellite.
3. Select the satellite (e.g. Astra 19.2E) and confirm with OK.
4. Now open the transponder list.
5. Press the YELLOW button to add a transponder.
6. Enter the appropriate data (eg: 12.188 H 27.500)
7. Press the MENU button to save the new transponder.
8. Search manually for new channels.
9. See point 7.1.2 Manual search (satellite)
Unicable settings
If you are using the TV with a Unicable system, you can enter the corresponding data
here.
Motor
Choose between Off, DiSEqC 1.2 or 1.3 (USALS)
Band
Choose between KU and C band.
Note: Usually you have to make no changes in the antenna settings. It is recom-
mended that only experienced users change settings.

7.1.6 Signal informations

In this menu you can see various informa-
tion about the respective transponder or
channel. Signal quality and level can be
read here.
ENGLISH
15