Stand Assembly - Megasat Royal Line II 19 Mode D'emploi

3. Stand assembly

1. For the assembly you need the following parts
Television
Note:
Before installing the stand, please check that you have all of the parts and that there
is no visible damage. If a part is missing or appears damaged, please contact custo-
mer service.
2. How to mount the stand
Place the TV face down on a soft and flat surface (blanket, foam, cloth, etc.) to prevent
any damage to the TV.
Note:
1. Before you put on the stand, please make
2. When you are putting on the stand, please
Insert the stand as shown on
the TV.
04
4x Screws
Stand
rear
front (longer)
sure the direction is correct as shown below.
make sure the neck of the TV set is in the
correct position and attached tightly.
ENGLISH
3. Stand assembly
Use a suitable screwdriver and attach the base with the screws provided. Make sure that the
screws are properly tightened.
3. WARNING
It can not be tilted to the front or back
as shown below. Doing so may damage
the stand.
It can not be tilted to the left or right as
shown below. Doing so may damage
the stand.
ENGLISH
05