Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
840114000 ENv07.qxd 1/15/04 9:16 AM Page 8
Troubleshooting
PROBLEM
Fryer gives off a
strong, unpleasant
odor.
Unit does not
heat.
During frying, the
oil spills over the
edge of the
fryer.
The oil foams too
much during
frying.
Condensation
forms on viewing
window.
8
Things TO CHECK
• The grease filter is saturated. Remove the lid and
clean the lid and grease filter in hot, soapy water.
• The oil isn't fresh. Change the oil. Filter oil regularly
to keep it fresh longer.
• The type of oil is not suitable for deep-frying food.
Use good quality frying oil. Do not mix two different
types of oil.
• Ensure magnetic cord assembly is properly attached
to the fryer socket.
• Ensure electrical cord assembly is plugged into
electrical outlet.
• Ensure timer is set to Stay On or a set amount of time
• There is too much oil in the fryer. Make sure that the oil
does not exceed the maximum level mark.
• The food contains too much liquid. Dry food thoroughly
before placing it in the fryer. Follow the instructions in
the "Frying" section on page 4.
• There is too much food in the frying basket. Do not fry
more food at one time than the quantities indicated on
the food package or the Frying Chart.
• The food contains too much liquid. Dry food thoroughly
before placing it in the fryer.
• The type of oil is not suitable for deep-frying food.
Use good quality frying oil. Do not mix two different
types of oil or fat.
• Oil pot has not been cleaned properly. See instructions
in the "Cleaning" section.
• Water vapor from the food collects on window.
When unit is cold, wipe a small amount of oil on inside
of viewing window to prevent condensation buildup.
(continued)
Publicité
Table des Matières
