Optional Rear Filler; Test Run - LG LSE5615 Serie Manuel Du Propriétaire

Optional rear Filler

If the counter does not bridge the opening at the rear
wall the rear filler kit, that is provided with the slide in
range, will be needed.
NOTE
If the countertop depth is greater than 25" there
will be a gap between the filler kit and the back
wall.
If the countertop depth is less than 24", the control
panel will not sit flush with the countertop.
Installing the rear Filler
1
Using a screwdriver, remove the six screws
holding the rear bracket in place and remove the
bracket.
2
Attach the rear filler to the range back, sliding
the hooks into the slots as shown. Slide the rear
bracket into the bottom opening in the rear filler.
hook
Rear bracket
Remove
Rear filler
3
Attach the rear bracket and filler assembly as shown,
using four of the six screws removed in step 1.
4
Store the remaining two screws with these instructions
for future use.

Test run

Check if the range is properly installed and run a test
cycle.
1
Turn the oven mode knob to the Off position to
start test.
2
Turn each knob to the Hi position to check that the
surface heating elements are working properly. The
elements should glow red and radiate heat, and they
should cycle on and off periodically even when the
knob is in the Hi position. This cycling prevents the
glass-ceramic from being cracked by thermal shock.
IMPOrTaNT : The Warming Zone does not consume
enough power to glow red.
3
*For Model : LSE5615 / LSE5613
After checking all the surface heating elements, check
the locking system by pressing Probe (LRE5615
model only) or Clock for three seconds. The oven
door should lock and the cooktop should not operate
while the Lockout function is turned on. Pressing
Probe(LSE5615 model only) or Clock for three
seconds to disable Lockout.
4
Now check the oven's operation. Turn the oven mode
knob to select the Bake mode. 350 °F appears in the
display. Press Start.
5
The oven should finish preheating in 15 minutes, and
the convection fan should operate while the oven is
preheating.
6
After checking the oven's operation, turn the
temperature up to 450 °F and leave the oven on for
at least an hour to help remove any oil which might
cause smoke and odors when first using the oven.
NOTE
Smoke may come out of the range when it is first
used.
INSTALLATION 15
Slot
Lower screws