Technical Specifications - Seac Q3 Instructions

• Shock-resistant ABS body.
• Spotlight optics.
• Smooth-surface reflector.
• Polycarbonate glass lens.
• Non-slip thermorubber ring nut body.
• Mechanical microswitch.
• 1 high light efficiency LED, Color temperature 4,250 °K.
• Twin O-ring fitted on lens seal.
• Battery holder specially shaped for parallel use of 4 or 8 batteries.
CHARACTERISTICS
Output
Volt
Type of batteries
Lumens rating
Battery housing
Light source
Color temperature
Light beam
Burntime, hours *)
Maximum depth
*) The burntime shown is approximate because it depends on the quality of
the batteries used. We recommend using high quality alkaline batteries. 1.2 V
rechargeable batteries commonly found on the market can also be used. If
rechargeable batteries are used we cannot guarantee the burntime and light
output shown on the technical sheet.
960-manuale seac Q3-Q1-rev B.indd 13

TECHNICAL SPECIFICATIONS

6 W
5.0 V
Requires the use of 1.5 V (R6) AA alkaline
batteries. 1.2 V rechargeable batteries of the
same size can also be used.
150
Compartment specially configured for use of 4 or
8 batteries in parallel
1 LED
4,250 °K
Concentrated
16 at full power
Over 25 at reduced power
100 m
Q1
English
08/02/2016 11.13.02
13