Best K7788 Mode D'emploi page 9

INSTALL THE DUCTWORK
(DUCTED HOODS ONLY)
NOTE: To reduce the risk of fire, use only
metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions
will reduce the performance of the hood.
Use as few of them as possible. Larger
ducting may be required for best
performance with longer duct runs.
4. Install a roof or wall cap. Connect round
metal ductwork to cap and work back to-
wards hood location. Use duct tape to seal
the joints between ductwork sections.
INSTALL ELECTRICAL
WARNING: Electrical wiring must be
done by a qualified person(s) in
accordance with all applicable codes and
standards. This range hood must be
properly grounded. Turn off electrical
power at service entrance before wiring.
1. Plan where the hood will be located
above the cook top. Refer to the
INSTALL MOUNTING BRACKET
section for hood mounting height
options.
2. Install a standard 2" x 4" wall outlet box
and 3-blade 125 Volt, 15Amp grounded
receptacle.
3. Mount the receptacle 20" to 26" above
the bottom of the hood Fig. 3
4. Locate the receptacle within boundary
shown and off center of the ductwork (to
allow for power cord plug and flue
clearance). Fig. 3
ROOF CAP
DECORATIVE
FLUE
HOOD
24" TO 30" ABOVE
COOKING SURFACE
(See "INSTALL MOUNTING
BRACKET" SECTION,
page 10, for mounting
restrictions)
CENTER LINE
OF HOOD
AND DUCT
- 9 -
ROUND DUCT
WALL
CAP
ROUND
ELBOW
6"
ADAPTER
8"
4"
20" - 26"
FIG. 3