EIBENSTOCK EOF 100 Notice Originale page 17

Switching on and off
The surface milling machine EOF 100 is equipped with a lock-off
button against unintentional switch-on.
1 2
Changing the Diamond Grinding Wheel
Attention!
The milling disk might heat up enormously during operation. You
could burn your hands or get cut or ripped by the segments.
Therefore, always use protective gloves when changing the grinding
wheel.
Before any work on the tool, disconnect the plug from the mains!
Switching-on: push the lock-off button forward (1) and
then the on/off switch down (2)
Switching-off: release the on/off switch
Actuate the spindle stop and keep it pressed.
Use the face spanner to unscrew the driving nut.
Then remove the milling disk respectively mount the
new one.
The assembly works the other way round!
Pay attention that the collar of the clamping nut faces
away from the machine, as shown in the figure.
In order to check whether the spindle stop is released
before you switch on the tool, turn the spindle slightly.
Let the machine run for a short period of time and in a
safe position. If the machine does not run easily, stop
working immediately.
Use only original accessory!
17