Ugolini MiniGEL Manuel De Service page 38

&
and remove it by pulling it out from the front.
10. 2 DISASSEMBLING THE CIRCUIT BOARDS
1 Remove the control board housing by pushing it down.
2 Disconnect all connectors at the rear of the board. Loosen all the housing securing screws and then remove the board itself.
3 To remove the power board, you need to disconnect all the connectors then pull down the two side anchor tabs and pull out the
board.
10. 3 DISASSEMBLING THE WATER COLLECTION TRAY
1 Remove the advertising picture at the rear by prising it off with a screwdriver inserted in the purpose-provided slot. Loosen the
38