Dahle ShredMATIC 35314 Mode D'emploi page 7

1
en Instructions
IMPORTANT!
Read the operating and safety instructions
BEFORE placing the document shredder
into operation.
You must follow the instructions.
Keep the operating instructions in a safe
place ready for later use.
Table of Contents
1 Important information . . . . . . . . . . . . . . . . 7
1.1 Intended use,
warranty . . . . . . . . . . . . . . . . . . . . . . . . . 7
1.2 Safety instructions . . . . . . . . . . . . . . . . . . . 8
1.3 Key to pictograms . . . . . . . . . . . . . . . . . . . 9
1.4 Scope of supply . . . . . . . . . . . . . . . . . . . . 88
1.5 Technical data . . . . . . . . . . . . . . . . . . . . 88
2 Operation . . . . . . . . . . . . . . . . . . . . . . . . 89
2.2 Connecting the device to the power supply . 89
2.3 Switching on the device . . . . . . . . . . . . . . 89
2.4 Paper shredding . . . . . . . . . . . . . . . . . . . 90
2.10 Continuous operation . . . . . . . . . . . . . . . 92
2.11 Locking . . . . . . . . . . . . . . . . . . . . . . . . . 93
2.14 CD, DVD & card shredding . . . . . . . . . . . . . 94
3 Maintenance/troubleshooting . . . . . . . . . . 96
3.1 Empty shredded waste . . . . . . . . . . . . . . . 96
3.3 Container/cover open. . . . . . . . . . . . . . . . 96
3.4 Overheating . . . . . . . . . . . . . . . . . . . . . . 97
3.5 Paper jam, manual intake . . . . . . . . . . . . . 97
3.7 Paper jam, automatic intake . . . . . . . . . . . 98
3.10 Paper jam, locked automatic
intake . . . . . . . . . . . . . . . . . . . . . . . . . . 99
3.13 Emergency unlocking without a key . . . . . 100
3.17 Cleaning the device . . . . . . . . . . . . . . . . 101
1.1 Intended use, warranty
The document shredder is intended to be used for
shredding paper.
Depending on the model variant, a small amount of
the following materials can also be shredded:
- CDs/DVDs, bank cards and credit cards (see techni-
cal data).
- The normal staples and paper clips found in paper
documents (exception: security level P6 and P7
devices).
The device has an automatic intake for paper stacks
that consist of individual sheets that are not folded
(max. 100 g/m²). Paper clipped together, either with
paper clips or staples, can generally also be pro-
cessed in the stacks. The precondition for this that
the clips should be on the rear side of the paper tray
(pointing away from the user). However, removing
the office clips/staples before shredding is recom-
mended to extend the life of the device. In indi-
vidual cases, depending on the quantity and position
of the clips and the thickness of the clipped stack,
misfeeding and hence an interruption of the shred-
ding process may occur.
Wear, damage due to improper use or unauthorised
modifications and repairs are not covered by the
warranty or the guarantee.
The document shredder was designed for private use
and for use in normal office environments.
The following conditions apply to the sheet capacity
specified under technical data:
Maximum number of sheets that are shredded in one
pass under the following conditions: New shredding
rollers, oiled if needed, cold motor, power supply
with rated voltage and rated frequency (230 V/50
Hz; 120 V/60 Hz).
7