Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000373-001.book Page 14 Thursday, February 14, 2019 1:16 PM
en
14
Adjustments.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Electronic torque shut-off (figure 6).
The electronic torque shut-off can be used
when working without depth stop.
Adjust the torque only when the machine is at
a complete stop.
The motor switches off when reaching the set
torque and an audio signal sounds. After the
shut-off has taken place, release the on/off
switch and press it again for the next screw-
driving operation.
The audio signal can be switched on and off.
For this, remove the battery and afterwards,
press and hold the On/Off switch. Mount the
battery again and release the On/Off switch
within 5 seconds. A swelling-up sound indi-
cates that the audio signal is on; a swelling-
down sound indicates that the audio signal is
off.
To set a higher torque (e. g. for large-diame-
ter screws), turn the dial control clockwise.
To set a lower torque (e. g. for small-diame-
ter screws), turn the dial control counter-
clockwise.
The electronic shut-off is deactivated when
working in the "
" torque level.
To achieve good working results, press the
power tool with sufficient force against the
screw.
Publicité
