Sienna SSM-4003 Manuel D'instructions page 6

6) Twist the quick release cord wrap (C) clockwise to un-wrap the power cord completely. Hang
the cord on the handle cord wrap (B) for better use of the steamer when moving and cleaning.
Be sure to plug unit into a grounded outlet.
7) The LED (I) will illuminate when the steamer is ready for cleaning.
NOTE: It is recommended that another high wattage appliance is not operated on the same circuit to
avoid a circuit overload.
CAUTION: Upon initial use, please allow the water to fl ow through the system for approximately
30 seconds to prime the unit. The pump will make a louder noise during this process.
WARNING: ON SURFACES THAT HAVE BEEN TREATED WITH WAX, THE WAX MAY BE
REMOVED BY THE HEAT AND STEAM ACTION. DO NOT USE ON UNSEALED WOOD FLOORS OR
LET UNIT STAND ON ANY WOOD FLOOR FOR AN EXTENDED PERIOD OF TIME. THIS MAY CAUSE
THE WOOD GRAIN TO RISE. IT IS RECOMMENDED THAT A SECTION BE TESTED IN AN ISOLATED
AREA OF THE FLOOR. IT IS ALSO RECOMMENDED THAT YOU CHECK THE USE AND CARE
INSTRUCTIONS FOR CLEANING FROM THE FLOOR MANUFACTURER TO ENSURE STEAM CLEANING
IS ACCEPTABLE FOR YOUR FLOOR.
8) Pull down on handle (A) to release and unlock steam for use. To stop steam, simply lift handle
(A) back to upright and locked position.
9) Slowly pass over surface to be cleaned when steam is emitted. It is recommended to sweep or
vacuum fl oor prior to using the steam mop.
CAUTION: To sanitize an area of your fl oor, leave the steamer over the area for a minimum
of 8 seconds, but no longer than 15 seconds. Leaving the steamer in a stationary position for a
longer period than recommended may cause build up of pale residue. This residue can be
removed by using a decalcifying product or with a few drops of vinegar on a cloth and wiped
away.
10) When steamer stops emitting steam simply refi ll the water tank (H) and continue cleaning.
WARNING: NEVER RUN THE STEAMER WITHOUT WATER.
11) When you fi nish cleaning, unplug power cord from outlet. Be sure to empty water tank (H)
6