Rollei Profi Funk-Sender Notice D'utilisation page 34

Operation
34
9 . How to set the Canon RT Mode (ZGB)?
Press the power switch shortly
will show the following sign
display . Then shortly press the CH button to switch the CH to ID . Press the
plus or minus button to change the value, so that the flash and the trigger
do have the same ID .
Note: Please note that some settings can only be changed directly in the
menu of the camera and not via the trigger . This goes especially for Canon*/
Nikon* cameras . Therefore please check the camera's manual . It might hap-
pen, that the flash settings of the trigger will be overwritten by the settings
in the camera's menu .
*Canon and Nikon are registered trademarks, Canon and Nikon products are trademarks or registered
trademarks of Canon and Nikon .
ENGLISH
, to open the RT mode (ZGB) . The display
. The signs CH / ID will be shown on the