Romus MR 630 Manuel D'instructions page 9

Multi-flooring Cutter MR-630 Multi-flooring Cutter MR-630
Réf. 93425 Réf. 93425
Installation of the cutter (1)
Pull up the lock pin on the aluminum
handle as show and insert the handle
base into the handle as show.
Warning: Do not put your fingers
against the sharp edge of the blade at
any time.
Installation of the Cutter (2)
Press the handle down and then pull
out the lock pin from the side frames
as shown.
Warning: Do not put your fingers
against the sharp edge of the blade at
any time.
SeT uP
9