Multi-flooring Cutter MR-630
Multi-flooring Cutter MR-630
Réf. 93425
Réf. 93425
MAInTenAnCe
Blade Sharpening
Use provided sharpening stone to
sharpen the blade edge several
times until you feel the blade is sharp
enough. Such sharpening does not
hurt the blade's sharpness or its life.
In the sharpening process, the blade
does not need to be taken off from the
blade holder.
Warning: Do not put your fingers
against the sharp edge of the blade at
any time.
Changing the Blade
Use the provided Allan wrench to re-
move the nine screws, then hold the
blade by each end and carefully move
the blade out of blade holder.
Note: the flat side of the blade facing
the table.
Warning: Do not put your fingers
against the sharp edge of the blade at
any time.
Carry
Hook the chain to the ring on the handle
and carry the cutter as shown.
11