Cutting Preparation - Romus MR 630 Manuel D'instructions

Massicot pour revêtements de sol
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Multi-flooring Cutter MR-630
Réf. 93425

Cutting Preparation

Adjust the angle attachment as nee-
ded and pull the extension handle out
as shown.
Warning: Do not put your fingers
against the sharp edge of the blade at
any time.
Straight Cutting
Insert material between the cutting
blade and the base, flush with the
angle attachment as shown and hold
the material with foot then push handle
down to complete a cut.
Warning: Maintain control of the
handle. Do not allow handle to slam
back after making a cut.
45° Cutting
Swing the angle attachment to 45°.
Insert material between the cutting
blade and the base, against the angle
attachment as shown, then push the
handle down to complete a cut.
Warning: Maintain control of the
handle. Do not allow handle to slam
back after making a cut.
CuTTIng
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

93425

Table des Matières