System Overview; Description; Component Identification - Maxtec MaxFLO2 High Flow R223P02 Manuel D'utilisation Et Mode D'emploi

1.0 SYSTEM OVERVIEW

1.1 Description

The MaxFLO is a compact air/oxygen gas mixing device. The MaxFLO
2
precise mixing of medical grade air and oxygen through two separate gas flowmeters
controlled by two separate flow control knobs. The sum of each individual gas flow
yields the total flow of gas, i.e. 25 LPM of oxygen and 15 LPM of air is a total flow of 40
LPM. Resulting oxygen concentration can be determined in several ways:
• With use of an oxygen analyzer/monitor mounted to the mixed gas analysis port.
• Referencing Table 1 in Section 2.2 of this Operating Manual.
Additional features and operational benefits include:
• Quick and easy intermittent or continuous oxygen measurements.
• No continuous bleed required, less wasted gas.
• Durable, compact design.
• Low maintenance.

1.2 Component Identification

1
2
3
4
5
1 Medical Air Flowmeter
2 Medical Air Flow Adjustment Valve
Medical Air Gas Inlet
3
4 Male DISS Fitting
5 22mm Male/15mm Female Conical
Outlet Fitting
6 Oxygen Flow Meter
866.4.Maxtec www.maxtec.com
866.4.Maxtec
9
6
7
8
7 Oxygen Gas Inlet
8 Oxygen Flow Adjustment Valve
IV Pole Clamp
9
10 Mixed Gas Analysis Port
11 Mixed Gas Analysis Port Cover
(Shown in open position)
www.maxtecinc.com
provides
2
11
10
1