Circuit Breaker Protection - Uline H-7645 Mode D'emploi

1. Plug power cord into properly grounded power
outlet.
2. Turn On/Off switch to the ON position. (See Figure 5)
3. To operate brush squeeze brush start triggers.
(See Figure 5)
4. Push vacuum forward to begin cleaning.
5. Adjust brush height for proper pick-up.
(See Brush Height Adjustment on page 4)
The vacuum comes equipped with two manual circuit
breakers (reset buttons), a 15 amp breaker for the
vacuum motor and a 2.5 amp breaker for the brush
motor. If vacuum does not turn on, check circuit breakers.
To reset circuit breakers:
1. Turn off and unplug vacuum.
2. Check vacuum for the following: Full bag,
obstructions, clogged filters, clogged brush or if
brush height is set too low
3. Press affected circuit breaker button to reset.
(See Figure 6)
4. Resume operation.
If vacuum fails to turn on, contact Uline Customer
Service at 1-800-295-5510.
• Keep vacuum clean and in good operating
condition.
• Change vacuum bags and filters as recommended
to maintain optimum cleaning efficiency.
• Always use OEM bags, filters and parts, as use
of other products may result in poor cleaning of
filtration performance. OEM products are designed
for maximum performance.
PAGE 5 OF 24
OPERATION

CIRCUIT BREAKER PROTECTION

MAINTENANCE
Figure 5
Brush
Start
Trigger
Figure 6
• Store vacuum carefully in a dry area.
• For optimum cleaning performance and safety,
follow owner's manual.
• After each use, carefully wrap power cord around
handle and check cord for wear or damage. If cord
is damaged, contact Uline Customer Service at
1-800-295-5510.
On/Off Switch
Brush
Start
Trigger
0621 IH-7645