Handle Adjustment; Bag Installation; Brush Height Adjustment - Uline H-7645 Mode D'emploi

HANDLE ADJUSTMENT

1. Loosen handle adjustment lock lever and adjust
handle to desired operating height. (See Figure 1)
2. Tighten handle adjustment lock lever to lock handle
in place. (See Figure 1)
Figure 1

BAG INSTALLATION

1. Position handle in normal operating position.
2. Open bag compartment lid and unzip cloth bag.
(See Figure 2)
Figure 2
Cloth
Bag
PAGE 4 OF 24
SETUP
3. Install paper bag inside cloth bag. (See Figure 3)
Figure 3
Paper
Bag
Cloth
Bag
4. Attach both bag openings together onto vacuum
intake housing. (See Figure 3)
5. Make sure bag is properly positioned inside
machine housing.
6. Completely close zipper on cloth bag and close
bag compartment lid.
NOTE: Always use cloth and paper bags
together.

BRUSH HEIGHT ADJUSTMENT

1. Vacuum has five brush adjustment levels. Raise
brush height level by lifting up height adjustment
Zipper
pedal to desired brush height. (See Figure 4)
2. Lower brush height level by pushing down height
adjustment pedal to desired brush height.
(See Figure 4)
Figure 4
Vacuum
Intake
Housing
Height
Adjustment
Pedal
0621 IH-7645