Calibrating The Paper Sensor - Citizen CT-E651 Mode D'emploi

3.12 Calibrating the Paper Sensor

Calibrate the paper sensor to suit the actual paper you are using before using label
paper or black mark paper.
Before executing this mode, use the paper selection mode or the MSW4-4 and MSW4-
5 settings to set the paper type you want to use.
1. Loading Media
Turn the printer power off and open the paper cover.
 Label paper sensor adjustment method
Check that MSW4-4: OFF and MSW4-5: ON.
Peel the label from the first roll paper and then set the roll paper in place with the printing
surface facing up.
Adjust the position of the paper so that the area where the label was removed is above the
bottom sensor.
1. Bottom sensor
Refer to 3.11 Selecting a Paper Type
Refer to 5.3 Manual Setting of Memory Switches
50
— —
1