Adjusting The Paper Near-End Sensor - Citizen CT-S300 Mode D'emploi

3.7 Adjusting the Paper Near-end Sensor

1. Push in the paper near-end sensor unit.
2. Move the paper near-end sensor unit to the right and left while pushing it.
The position to be set varies in accordance with the setting of the printer,
horizontal or vertical, or the diameter of the paper roll as shown in the
following figure.
Sensor Position
1
2
3
4
5
6
Paper near-end sensor unit
CAUTION!
G Paper remainder (outside diameter of roll) differs by the type of paper roll used.
G The external diameter of the paper roll is only for reference.
Installation Method
Horizontal
Vertical (Wall-mounted)
2. Move
1. Push
— 16 —
Paper Roll External Diameter (mm)
φ22
φ24
φ27
φ27
φ24
φ22
6
5
4
Sensor
position
3
2
1