Adjusting The Side Brushes - BM2 BIEMMEDUE DUSTY 1100 ET Mode D'emploi Et D'entretien

bracket
Remove the filter and clean (or if necessary replace) with
•
compressed air, keeping the air jet at least 20 cm away.
The filter can be washed with water. Make sure it is
completely dry before replacing.
8.4.10 Replace the elastic belts
The brushes are driven by means of elastic belts. To replace in the
event of wear:
Remove the side guards;
•
side panel fixing
screws
Move the sponge rubber insulation;
•
Lengthen the belt to be replaced and remove from the
•
pulleys;
To replace the central brush drive belt, the side brush
•
belt must first be removed;
Proceed in the same way to mount the new belt;
•
Replace the side guards.
•
The belt for the other side brush is on the other side.
wing nuts
8.4.11
To adjust the height of the side brush, slacken the lock nut and
adjust the stop under the brush arm.
8.4.12
To replace the cable, proceed as follows:
When positioning the sponge rubber insulation, make
•
sure the slots are positioned correctly.
sponge rubber
insulation

Adjusting the side brushes

Replacing the side brush raising cable
Move the side brush lever forwards;
•
Remove the side guards;
•
Unscrew and remove the clamp on the brush arm;
•
brush arm clamp
Unscrew the clamp on the lever;
•
centre brush belt
side brush belt
pulleys
stop