BM2 BIEMMEDUE DUSTY 1100 ET Mode D'emploi Et D'entretien page 23

Place the brush on the pulley;
•
Fasten the brush to the pulley by tightening the three
•
screws.
Put the machine back on the horizontal;
•
It now requires filling with fuel;
•
Open the seat cowling until the support rods lock into
•
place;
Unscrew the fuel tank cap;
•
Fill with fuel, close the tank and lower the seat cowling;
•
If not ordered at the moment of purchase, the 12V 20 Ah
•
starting motor battery must be mounted.
The electric model requires additional operations depending on the
order:
screws
cowling
support rod
tank cap
Remove the black guard between the levers at the base
•
of the handlebar;
Position the battery in the battery compartment and
•
connect the cables to the terminals (RED positive -
BLUE negative).
BLUE (-)
negative
battery
If the batteries were ordered together with the machine,
they will already be mounted and checked by the
Manufacturer and before use the side brushes must be
mounted as described above;
IMPORTANT - Do not tilt the machine with the
batteries mounted: remove the batteries before
tilting the machine.
If this is not the case, the customer must obtain 2 x 12 V
140 Ah batteries (with relevant 24V and 10A battery
charger) and perform the following operations.
IMPORTANT - Do not use battery chargers with
different powers to charge the batteries
Open the seat cowling;
•
Place the batteries on the brackets;
•
Fix the batteries in position by tightening the wing nut on
•
the threaded vertical bar;
Connect the batteries in series as shown below (the
•
positive and negative terminals are differently shaped
and cannot therefore be reversed);
RED
positive
BLUE
negative
Verify the level of electrolyte inside the elements;
•
Leave the cowling open while charging is underway to
•
ensure adequate ventilation of the battery compartment;
Charge the batteries by plugging the battery charger
•
connector into the socket on the left of the machine;
RED (+)
positive
BLUE
negative
machine cables
RED
positive
connecting cable