Lubrication - Bostitch BCF28WW Manuel D'instructions

English
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Daily Maintenance Chart
ACTiOn: Clean magazine, pusher, and contact trip
mechanism.
WhY: Permits smooth operation of magazine, reduces
wear, and prevents jams.
hOW: Clean tool with a clean, damp cloth. Do not oil
or lubricate this tool. The use of oils, lubricants
or solvents is not recommended as they tend to
attract debris.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.

Lubrication

nOTE: nEVER spray or in any other way apply lubricants or
cleaning solvents inside the tool. This can seriously affect
the life and performance of the tool.
BOSTITCH tools are properly lubricated at
the factory and are ready for use. However,
it is recommended that, once a year, you
take or send the tool to a certified BOSTITCH
service center for a thorough cleaning and
inspection.
Accessories

WARNING: Since accessories, other than those
offered by BOSTITCH, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only BOSTITCH
recommended accessories should be used with
this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact BOSTITCH Industrial Tool
Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-BOSTITCH (1-800-262-2161) or visit our website:
www.BOSTITCH.com.
14
Replacement Parts

WARNING: To reduce the risk of personal injury,
disconnect battery pack from tool and engage trigger
lock-off before performing maintenance, or clearing a
jammed nail.
Use spring replacement kit: BCF-RSK
Use only identical replacement parts. For a parts list or to
order parts, visit our service website at www.BOSTITCH.
com . You can also order parts from your nearest BOSTITCH
Factory Service Center or BOSTITCH Authorized Warranty
Service Center. Or, you can call our Customer Care Center at
(800) 262-2161.
Return Spring Replacement Kit

WARNING: For your own safety, read the tool
instruction manual before using any accessory.
Failure to heed these warnings may result in serious
personal injury and damage to the tool and the
accessory. When servicing this tool, use only identical
replacement parts.
nOTE: All the mechanical parts of the spring replacment
kit are shown for convenience and verification of inclusion.
The kit also contains a packet of Loctite adhesive for use in
step 9.
To change broken return springs:
nOTE: Springs should be replaced as a pair, using only the
correct BOSTITCH accessory spring replacement kit.
1. Using the hex wrench
screws on either side of the unit. Refer to Figure P.
18
Fig. P
2. Remove the return system
Figure Q.
Fig. Q
3. Slide the spring rail clip
Refer to Figure R.
provided, loosen the two
11
11
18
19 from the unit. Refer to
19
off of the spring rail
20
.
21