Speed Selection; Loading The Tool - Bostitch BCF28WW Manuel D'instructions


WARNING: Do not keep trigger depressed when tool
is not in use. Keep the trigger lock-off in the locked
position when the tool is not in use.

WARNING: When the tool's motor is running, the
next actuation, pulling the trigger or depressing the
contact trip, will cause a nail to fire.
Dry Fire Lock out
The nailer is equipped with a dry fire lockout which prevents
the tool from actuating when the magazine in nearly empty.
When approximately 7 to 9 nails remain in the magazine,
the tool ceases to operate. Refer to Loading the Tool to
reload a stick of collated nails.

Speed Selection

This nailer is equipped with a dual speed selection switch
located on the foot.
13
• For shorter nails, select speed 1 by setting the switch to
the left most position.
• For longer nails and more rigorous applications, select
speed 2 by setting the switch to the right most position.
nOTE: In the event that nails are not driving to depth in
speed setting 1, you may have to switch to speed setting 2
for additional driving power.
nOTE: Firing nails under 3-inches in length using Speed
Setting 2 will cause excessive wear to your tool and may
result in early failures.
Fig. H
Suggested Speed Settings
Application Typical Nail Length
Framing & Decking 3-1/4" - 3-1/2"
(8.255 cm, 8.89 cm)
General Framing
Sheathing 2–3/8" (6.03 cm)
Fencing
Using the Trigger Lock-off

WARNING: To reduce the risk of serious personal
injury, do not keep trigger depressed when tool is not
in use. Keep the trigger lock-off switch LOCKED (Fig. I)
when the tool is not in use.

WARNING: To reduce the risk of serious personal
injury, lock off trigger, disconnect battery pack from
tool and remove nails from magazine before making
adjustments.
13
Speed Setting
3" (7.62 cm)
2" (5.08 cm)
This BOSTITCH nailer is equipped with a trigger lock-off
2 which when pushed to the right as shown in Figure I,
prevents the tool from firing a nail by locking the trigger and
bypassing power to the motor.
When the trigger lock-off is pressed to the left, the tool will
be fully operational. The trigger lock-off should always be
locked off (Fig. I) whenever any adjustments are made or
when tool is not in immediate use.
nOTE: Do not store tool with battery pack installed. To
prevent damage to the pack and to ensure best battery life,
store battery packs out of the tool or charger in a cool, dry
location.
Fig. I

Loading the Tool


WARNING: Keep the tool pointed away from yourself
and others.

WARNING: Never load nails with the contact trip or
trigger activated.

WARNING: Always remove battery pack before
loading or unloading nails.

CAUTION: Keep fingers clear of pusher latch track to
prevent injury.

WARNING: The trigger lock-off should always be
engaged whenever any adjustments are made or
when tool is not in use.

WARNING: Since accessories, other than those
offered by BOSTITCH, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only BOSTITCH
recommended accessories should be used with this
product.
2
1. Turn the nailer upside down.
2. Slide the spring-loaded pusher latch
1
the magazine to lock it into place as shown in Figure J.
3. Drop nail strips into the loading slot of the magazine,
1
making sure the nail heads align correctly with the slot
1
opening. (Refer to nail specifications to determine
compatible size.)
4. Keeping fingers clear of the track, close the magazine by
releasing the pusher latch. Carefully allow the latch to
slide forward and engage the nail strip.
English
2
8 to the base of
11