Mode Selection - Bostitch BCF28WW Manuel D'instructions

English

WARNING: To reduce the risk of personal injury,
disconnect battery pack from tool and engage trigger
lock-off before performing maintenance, clearing
a jammed nails, leaving work area, moving tool to
another location or handing the tool to another
person.

WARNING: Always wear proper eye [ANSI Z87.1
(CAN/CSA Z94.3)] and ANSI S12.6 (S3.19) hearing
protection when operating tool.

WARNING: Keep fingers AWAY from trigger when not
driving fasteners to avoid accidental firing. NEVER
carry tool with finger on trigger.
1. Wear proper eye, hearing and respiratory protection.
2. Remove battery pack
lock-off 2 .
3. Lock the pusher in the (back position and remove all nail
strips from the magazine
4. Check for smooth and proper operation of contact
trip and pusher assemblies. Do not use tool if either
assembly is not functioning properly.
5. Never use a tool that has damaged parts.
To Operate The Nailer

WARNING: The contact trip needs to be depressed
followed by a full trigger pull for each nail followed
by a release of both the contact trip and trigger after
each nail.

WARNING: The battery should always be removed
and the trigger lock-off engaged whenever any
adjustments are made or when tool is not in use.
1. Fully depress contact trip
and motor will start.
2. Fully pull trigger . (nail will drive into work surface).
1
3. Release trigger.
4. Lift contact trip off work surface.
5. Repeat steps 1 through 4 for next application.

Mode Selection


WARNING: Always wear proper eye [ANSI Z87.1
(CAN/CSA Z94.3)] and ANSI S12.6 (S3.19) hearing
protection when operating tool.
The framing nailer is capable of firing nails using bump
actuation or sequential actuation. If you would like to
have the bump actuation mode disabled, have the tool
serviced by an authorized BOSTITCH service center. Before
operating this tool, look at the selector switch to determine
the actuation mode. Read all instructions before selecting
actuation mode.

WARNING: Keep fingers AWAY from trigger when
not driving nails to avoid accidental firing. Never
carry tool with finger on trigger. In bump mode tool
will fire a nail if contact trip is bumped while trigger
is depressed.
Sequential action
Use sequential action for intermittent nailing where
very careful and accurate placement and depth control
10
12 from tool and engage trigger
.
7
6 against the work surface
is desired. The sequential actuation mode provides the
maximum delivery of power for driving the longest nails.
To operate the nailer in sequential action mode:
1. Slide the selector switch to the left, as shown in Figure
F.
2. Fully depress nosepiece against the work surface (motor
will start).
3. Pull trigger (nail will drive into work surface).
4. Release trigger.
5. Lift nosepiece off work surface.
6. Repeat steps 2 through 4 for next application.
nOTE: The contact trip needs to be depressed followed by
a trigger pull for each nail followed by a release of both the
contact trip and trigger after each nail.
Fig. F
Bump action
Bump action is intended for rapid nailing on flat, stationary
surfaces and typically most effective for applications that
require driving shorter nails.
When using bump action, two methods are available: place
actuation and bump actuation.
Slide the selector switch to the right, as shown in Figure G.
Fig. G
To operate the tool using the place actuation method:

WARNING: A nail will fire each time the trigger
is depressed as long as the contact trip remains
depressed.
1. Depress the contact trip against the work surface.
2. Depress the trigger.
To operate the tool using the bump actuation
method:
1. Depress the trigger.
2. Push the contact trip against the work surface. As long
as the trigger is depressed, the tool will fire a nail every
time the contact trip is depressed. This allows the user
to drive multiple nails in sequence.