Selection Of Swaging Clamps - OP TUBOMATIC H48 EL Manuel D'utilisation Et De Maintenance

OP
S.r.l.
25131 BRESCIA - Via Serpente, 97 - Tel. 030/3580401 - Fax 0303580838
________________________________________________________________________________________________________________

SELECTION OF SWAGING CLAMPS

THE SERIES OF CLAMPS INDICATED IN THE FOLLOWING TABLE ARE AVAILABLE
note :
FOR THE TUBOMATIC H48 EL. ORDER THE NECESSARY SETS OF CLAMPS.
ON REQUEST, WE CAN SUPPLY CLAMPS WITH SPECIAL NOMINAL DIAMETERS.
E
N Order code
G
L
I
TUBH46M10
S
TUBH46M12
H
TUBH46M14
TUBH46M16
TUBH46M19
TUBH46M23
TUBH46M27
TUBH46M31
Clamp holders
MANUAL REPLACEMENT OF CLAMPS (PICTURE 2)
After selecting the sets of clamps required, with reference to the diameter of the pipe;
proceed as follows:
1. Move back the piston in order to open the dies and have enough space to work in the
pressing area.
2. Insert the suitable magnetic tool,(pos. 1 fig.2) hooking the die in order to make it
come out from the seat of the master dies pulling up the magnetic lever. Repeat the
operation for the remaining dies.
3. Insert the new dies with the suitable magnetic lever, making a little pressure in the
hole of the master dies. Repeat the operation for the remaining dies.
TABLE B: DATA ON AVAILABLE CLAMPS
Minimum/nominal
swaging Ø (mm)
10
12
14
16
19
23
27
31
39
Maximum
advised swaging
Ø (mm)
12
14
16
19
23
27
31
39
46
34
Clamp lengths
55
55
55
55
55
55
65
65
64